GO TOP

Heat Pump Blowing Cold Air in a Concord Winter? What’s Normal

Trident Mechanical Systems technician checking refrigerant pressures on an outdoor unit in the Concord, NC area

A heat pump blowing cold air in January is often working fine, and sometimes it’s telling you a part has failed. This guide covers what’s normal in a Concord winter (defrost cycles, AUX and EM heat, long run times), what to check first, and which signs mean a repair.

Is your heat pump really blowing cold air?

Often the air isn’t cold, just cooler than you expect. A heat pump in heat mode usually sends air to the vents somewhere between the mid-80s and about 110°F, while a gas furnace runs much hotter. Air below body temperature feels cool on your hand even while it warms the room, so if you’re used to a furnace, a working heat pump can feel like it has quit.

For a better read than your hand, hold a kitchen thermometer in a supply register for a few minutes while the system runs. Air in that range, with the house holding the temperature you set, means the heat pump is doing its job. Air near room temperature, or a house that keeps losing ground, points to one of the problems below.

What does a defrost cycle look and feel like?

A defrost cycle is the heat pump briefly running in reverse to melt frost off the outdoor coil, and it’s normal winter operation. In heat mode the outdoor coil runs well below the outdoor air temperature, so it can frost over on a damp morning in the upper 30s or even the 40s, which describes plenty of Concord winter mornings. During defrost the outdoor fan stops, you may hear a whoosh as the system switches over, and steam can rise off the unit. Most units defrost every 30 to 90 minutes while frost is building, and a typical cycle lasts about 5 to 10 minutes.

Backup heat normally runs during defrost, so you shouldn’t feel much change indoors. If you get a blast of cold air at every defrost, the backup heat may not be working. On many systems it has its own breaker in the panel, separate from the outdoor unit, so check that first. Homes without electric backup heat, and some dual-fuel systems, may feel a few minutes of cooler air, which is normal.

What do AUX and EM heat mean on your thermostat?

AUX (auxiliary) heat means the thermostat has brought on your backup heat to help the heat pump. EM (emergency) heat means the heat pump is switched off and the house is running on backup heat alone. In most Concord heat pump homes the backup is electric heat strips in the indoor air handler; in a dual-fuel home it’s a gas furnace. AUX coming on is normal during defrost, on cold days (often below about 40°F), and when you raise the setpoint more than a few degrees at once. Electric backup heat costs much more to run than the heat pump, which is why bills climb in a cold snap. Our heat pump vs. furnace guide for Concord covers running costs.

Thermostat showsWhat it meansCall if
AUX or AUX HEATBackup heat is helping the heat pumpIt stays on most of the day above about 40°F
EM HEAT or EMERGHeat pump is off, backup heat onlyYou had to switch it on. It’s a stopgap until the repair
DEFROST or a snowflakeThe outdoor unit is clearing frostDefrost runs back to back, or the ice stays

Labels vary by thermostat brand.

Why does a heat pump run nonstop on the coldest nights?

Long run times on cold nights are normal. Heating equipment around Concord is sized for a winter low of about 21°F, so on nights near or below that a heat pump may run almost constantly and lean on AUX heat to hold the setpoint. It’s matching the heat the house is losing, not failing.

Running nonstop in mild weather is different. If the heat pump runs all day in the 40s or 50s and the house still can’t reach the setpoint, or AUX is on most of the time, have it checked. The usual causes are low refrigerant from a leak, a dirty coil, an airflow problem, or a heat pump too small for the house.

What can you check before you call?

A few safe checks clear up a lot of heat pump cold-air problems. If there’s no heat at all, or your home has a furnace, start with our no-heat checklist for Concord homes instead. For a heat pump:

  • Thermostat: set to HEAT with the setpoint above room temperature, and the fan on AUTO. ON runs the blower between cycles, which feels cold.
  • Air filter: replace it if it’s clogged. Restricted airflow can make a heat pump blow lukewarm air.
  • Breakers: the outdoor unit and the indoor air handler have separate breakers, and backup heat often has its own. Reset a tripped one once.
  • Outdoor disconnect: the switch on the wall beside the outdoor unit should be on.
  • Outdoor unit: keep about two feet clear of leaves, snow and stored items, and make sure a gutter isn’t dripping onto it. That water can freeze on the coil faster than defrost clears it.
  • Outdoor fan: it should spin in heat mode, except during defrost.

Don’t chip ice off the coil, pour hot water on it, or remove panels. The fins bend and puncture easily.

When is cold air a repair?

Call when the air stays cold through a full cycle in HEAT mode, or when the outdoor unit has a problem the checks above don’t clear. The usual causes are a stuck reversing valve (the part that switches a heat pump between heating and cooling), a failed defrost control board or sensor, a refrigerant leak, or an outdoor unit that has stopped running. One Trident customer described a 14-year-old heat pump “stuck in the cooling cycle,” a reversing valve failure. Call if you notice:

  • Cold air in HEAT mode for a full cycle while the outdoor unit runs
  • An outdoor unit that won’t run, or a breaker that trips again after one reset
  • Ice thicker than about 1/4 inch, a solid coat of ice, or ice still there after defrost
  • Defrost cycles that run back to back or never seem to start

If the outdoor unit is heavily iced or not running, switch the thermostat to EM heat. That keeps the house warm and stops the heat pump from running against the ice until a technician looks at it. Don’t leave EM heat on once the heat pump is repaired, since it costs much more to run.

How does Trident handle heat pump repair in Concord?

Trident Mechanical Systems repairs heat pumps of all makes and answers heating calls 24/7, 365 days a year, from our shop at 1144 Union St S in Concord. Our team brings more than 20 years of HVAC expertise, with a registered North Carolina Professional Engineer on staff. When you call, tell us what the thermostat shows and whether the outdoor unit is running or iced. If you’re not satisfied, your service fee is free.

Frequently Asked Questions

Should I turn my heat pump down at night?

Keep setbacks small. Raising the setpoint more than a few degrees at once brings on AUX heat to catch up, which can cancel out the overnight savings. A degree or two, or a thermostat set up to warm a heat pump home gradually, avoids it.

Does a heat pump need a tune-up before winter?

A yearly tune-up checks the parts behind most winter cold-air calls: refrigerant charge, the outdoor coil, defrost controls and backup heat. It lowers the odds of a breakdown but can’t rule one out. Trident Mechanical Systems offers tune-ups through our maintenance plan.

Get Your Heat Pump Checked in Concord

If your heat pump still blows cold air after these checks, call Trident Mechanical Systems at (704) 467-8441 or request heating repair in Concord. We serve Concord, the rest of Cabarrus County and the surrounding Charlotte area around the clock.

GO TOP